Directions for use: Victoza and Saxenda
- Wash your hands thoroughly with soap and water.
- Pull off the pen cap.
- Visually inspect the solution. Do not use if it is cloudy, discoloured, or contains particles.
- Disinfect the pen tip with an alcohol wipe.
Priming a new pen
- Attach the needle and remove the caps.
- Turn the dose selector until the flow check symbol ( -- ) aligns with the pointer.
- Hold the pen vertically with the needle pointing up. Gently tap the pen tip to collect air bubbles at the top.
- Holding the pen with the needle pointing up, push and hold in the dose button until the dose display shows 0 mg. You should see a drop on the needle tip. If there is no drop, repeat the steps above.
Daily use of the pen
- Attach the needle and remove the caps.
- Turn the dose selector until the dose display shows the dose prescribed to you by your doctor. Do not touch the dose display during the injection as this could interfere with the injection.
- The abdomen, thighs and upper arms are the preferred injection sites.
- The medication should be injected under the skin (subcutaneous injection). Do not inject into a vein or muscle.
- Clean the injection area with soap and water before injecting.
- Insert the needle into the skin and hold down the dose button until the dose display shows 0 mg. Wait 6 seconds before removing the needle from the skin.
- Safely remove the needle and put the pen cap on.
Always dispose of the needle after each injection because it could be dirty or blunt. Dispose of needles in a sharps container and return to the pharmacy when full.
[UNIPRIX] © Copyright Vigilance Santé
The patient information leaflets are provided by Vigilance Santé Inc. This content is for information purposes only and does not in any manner whatsoever replace the opinion or advice of your health care professional. Always consult a health care professional before making a decision about your medication or treatment.